Fostex B16 Tension arm rear pin stop This has to go by

This has to go by courier because of size

However I made a test jig and have tested these and got a few that worked

8mm wide 1

Used in the Tascam 38 though some of the parts may have been used in other 1/2 inch machines

Fostex B16 Tension arm rear pin stop This has to go byThis was from the Model B16 but may have been used on later models, in principle on some of the machines there was a steel pin on which was a bottom metal bush that locked onto the pin, then two bearings was slotted through the pin and finally on top there was a cap . Both the cap and the bush have set screws in them to lock them into place, the whole assembly then slides into the tension arm where the pin is tightened up with a screw that holds it