Teac Tascam Pinch wheel 5800291500 1/2 inch for refurbishment ideally suited to someone restoring

ideally suited to someone restoring a machine board by board

This sits behind the flat reel table and in front of the back bush and then motor and has the

it has a 6MM shaft hole

there is a PCB on the rewind motor thats not present on the take up motor (this is the left one when looking at the machine

Teac Tascam Pinch wheel 5800291500 1/2 inch for refurbishment ideally suited to someone restoringThese are USED pinch wheels which I believe were used on the models listed below, many people selling pinch wheels now are often selling new but old stock, the life of a wheel in service is about 4 years if used all the time but should be changed anyway after that, units that are older or sit around on the shelf are still aging On old units they glass up or worse turn into a really gooey sticky mess. You just cannot sell a new but old stock pinch